Centrifugal pump Company SKOMI, mod. 8 x 6 x 14, Starter tied, Impeller 13 "

Scomi Oiltools centrifugal pumps are available in the following sizes from 3 x 2 x 13 inches to 8 x 6 x 14 inches and can be supplied in various configurations depending on customer requirements.
In the process of developing this model, considerable attention was paid to the features of its design, computer modeling, the quality of the materials used, as well as the production technology, which ensures unsurpassed performance properties and the service life of these pumps and their components.
Complete interchangeability of parts with other centrifugal pumps that are used to process drilling fluids using circulating mud cleaning systems.

CHARACTERISTICS AND ADVANTAGES
• Shaft made of high strength steel
• SKF bearings and tungsten carbide mechanical seal
• Spare parts for Scomi Oiltools are interchangeable with parts of other common centrifugal pumps
• Each pump mounted on the frame, which provides convenient access during maintenance and repair, as well as installation and dismantling.
• The large-diameter shaft has a replaceable sleeve that allows replacement of the worn-out part in the seal area without replacing the shaft itself. Minimal shaft deflection helps to extend the life of the packing seal.
• Front bearings, closer to the impeller of the pump, are double-row ball bearings, withstand a large radial load, and allow the installation of large impellers. The rear bearings, closer to the engine, are thrust bearings that are able to absorb double-sided axial loads in pairs. The design of this unit has a relatively high rigidity and is able to perceive bending moments.

SPECIFICATIONS
Case: Cast Iron
Shaft: low alloy steel
Shaft sleeve: stainless steel
Stuffing box: steel / cast iron
Wear plate: Steel
Labyrinth seal: Bronze
Mechanical Seal: Heavy Duty Tungsten Carbide

Application:
Fresh water
Sea water
Drilling mud

Pump sizes:
3 x 2 x 13 ”
4 x 3 x 13 ”
5 x 4 x 14 ”
6 x 5 x 11 ”
6 x 5 x 14 ”
8 x 6 x 11 ”
8 x 6 x 14 ”

Sizes of drive electric motors:
Explosion proof from 25 to 200 hp

Equipment:
1) Pump complete with electric motor:
a) the location of the electric motor on the same frame with the pump
b) the location of the electric motor above the pump (rotation through a belt drive)
2) Delivery of the pump separately from the electric motor
3) Starters are equipped with a special order.

SCOMI Centrifugal Pump, Type 8 x 6 x 14 with 13 "Impeller, Replaceable Casing Wear Pad and Tungsten Carbide Mechanical Seal mounted on an Oilfield Base with Woods Coupling 100HP 1500RPM Explosion Proof Motor, 380V, 3PH, 50Hz. C / w Electric Starter ( wired to motor)