Screw Compressor Crossair CA-5.5-8(10)Ra

Advantages:

• Protection class IP 55
• Engine Starting Star (Y) - Delta
• Electronic control system controller MAM-KY02S
• LCD (4-line liquid crystal display)
• Interface language – Russian
• Control of filter element clogging
• Control of the direction of engine rotation
• Monitoring the voltage supplied to the compressor, protection function against overload and short circuit.

• Performance	0.7 (0.6) m3/min
  Pressure	8(10) bar
  Power	5.5 kW
  Protection, IP	IP55
  Cooling type	air
  Noise indicators	63 dB
  Voltage	380 V
  Connection size, inches	3/4"
  Weight	135 kg
  Drive type	belt
  Guarantee	12 months
  Length, mm	792
  Width, mm	642
  Height, mm	710
  Oil-free	No
  With dehumidifier	No

• Service for the CrossAir CA-5.5-8(10)RA screw compressor

• Our service center performs the following types of work:
• Pneumatic audit
• Installation and supervision of pneumatic mains
• Pre-sale preparation
• Commissioning of compressor equipment
• Training in operating compressors and related equipment
• Scheduled maintenance of compressors according to regulations (the standard regulations are presented in the table below)
• Troubleshooting and troubleshooting
• Warranty and post-warranty repair of compressor equipment
• The work described in paragraphs 1-6 is performed at the Customer's site. Service center visits are charged separately.
• The work described in paragraphs 7-8 is performed on the premises of our company's service center, unless otherwise specified in the Supply Agreement.
• List of maintenance works for screw compressors

• Types of work	Maintenance regulations
  	Daily	500 hours	2,000 hours	4,000 hours	8,000 hours	20,000 hours
  External inspection for mechanical damage, oil leaks, and abnormal noise during operation. Troubleshooting if any. Checking the oil level; Checking oil separation; Checking the tightness of pneumatic system connections; Monitoring the instrument panel readings.	✔	✔	✔	✔	✔	✔
  Checking the condition of the cooling radiator. Cleaning if necessary; Checking the oil condition. Replace if necessary; Checking electrical equipment, wiring and connections.		✔	✔	✔	✔	✔
  Replacing the air filter; Checking the drive belt tension. Adjusting if necessary.			✔	✔	✔	✔
  Oil change*; Oil filter replacement*; Replacing the oil-air separator; Checking safety valves. Replace if necessary; Check the condition of the receiver (if available).		✔	✔	✔	✔	✔
  Belt replacement; Replacing the suction valve; Replacing the minimum pressure valve; Replacing the thermostat; Replacing the screw block seal kit.					✔
  Replacing the screw block repair kit; Replacing electric motor bearings.						✔

• * The first oil and oil filter change is performed after 500 hours of operation.

• Subsequently – every 2000 hours of operation, but not less than once a year.

• ** When using specific oils, the service interval increases from 2000 hours to 3000 hours.

• Typical of a limited number of manufacturers. One of them is Dalgakiran